Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

altremote_update - application image mode

Hi, I know there are plenty of threads on this subject, I did read them but I am still confuse. I am using a Cyclone III EP3C10F256C8 FPGA and ECPS16. My intention is to upload the firmwa...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

No, after starting up in Factory image after power-up, it is sufficient to write the boot address for the Application image in parameter 4, write 0 to parameter 3 (disables watchdog) and set the reconfig pin of altremote_update high.