Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

about the error: Port "" does not exit in macrofunction \"NIOS"\

Dear friends I am a new user of the product named motionfire kit. Now, I meet a difficulty and want to consult you. when I started compilation for the FPGA project of motionfire kit, there a...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

The MotionFire Board using Cyclone 3 with Uart ports RS232 i'm using converter from RS232 to USB and i'm trying to program this board using USB Blaster. I'm trying to program it by Active or Passive serial but no result, Quartus II Programmer show No Hardware :(

It's weard because i can easyly control board by hyperTerminal connecting by port com4 which is USB converter.