Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

UART Pin Assignment

Hy there, another newbie question. I made applied UART function into my system (created in Quartus II). My question is it needed to apply any pin assignment to this UART in Quartus II? (since i ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

Thank you for your reply Akira,

I think I got your point on pin assignment,.

"can you solder?" << Yes :o

I have another simple(newbie) question, how can the system (SOPC) can communicate with my board ? by using this RS232?

My problem is I dont know if it's necessary to use this RS232 function on my SOPC. Since I am just learning to build an SOPC, so I was just following the my reference book(which is Chinese book, damn ! it made me headache by just reading it since my Chinese is worse than my English :eek:)

After I surfing on the internet, i think I dont need this UART/RS232 if my objective is just to communicate between SOPC and my board.

Looking forward to your guidance:o.

Thank you,

Yuyex :o