Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorTSE MAC and Marvell 88E1111
I'm having trouble to bring up the TSE MAC to Ethernet interface on the Stratix II GX PCIe board. I was able to instantiate a triple speed Ethernet MAC and build logic around it. The loopback at the ...
Altera_ForumHonored Contributor
Honored ContributorHello,
I read this discussion but i have question: have you somebody uClinux running on StratixIII DSP kit with TSE Marvell 88E1111 ethernet chip ? Everything looks ok, but don´t work ... When i use the />ifconfig eth0 hw ether 00:07:ed:ff:4a:d7 />ifconfig eth0 192.168.1.234 />ifconfig eth0 up />route add default gw 192.168.1.254 linux report - Trying 10/HALF - in this moment i don`t know what it does ? After this i try ping to ip of my pc, it finish by request timeout (and tx led on board don`t blink). I haven`t problem with reset i think, because examples of webserver (on uC-OSII) work fine and simple socket server too. Where could be mistake ? Thank you very much. Jan Naceradsky, Czech Reublic
