Forum Discussion
gongmh
New Contributor
New ContributorThe question about arria10-netlength
I downloaded this table from the official website, but there are two columns in it: Total Length (mm) and Total Delay (ps). Which data should I take as the criterion? What value should I set in the PIN DELAY of the PCB?
2 Replies
Farabi_AlteraRegular Contributor
Hello,
I am sorry, we dont see any table. Did you attached any files?
regards,
Farabi
gongmhhello,
sorry ，I could not replyed on the basis of the previous one. The Intel Community team has resolved this issue.
now you can see the link :Re: Re:The question about arria10-netlength - Intel Community thanks a lot .
best wishes.
