Stratix IV GX loop-back on different channel using HSMC loopback card?

Question

Hello,

I'm using Stratix IV GX Dev-kit. I have problem to create a loopback on transceiver (TX0 to RX1) using dev-kit HSMC loopback card. I looked into lots of the user manual but still could not figure out the solution:(. Anyone can advice me on this?:confused:

altera_forum · Answer

i think you'll have to build/modify an HSMC card to do that

Forum Discussion

Stratix IV GX loop-back on different channel using HSMC loopback card?

1 Reply

Recent Discussions

AGILEX 5 cvp mode

Arrow AXE5 Eagle Board JTAG issue

PDN file and PCB decoupling

PCIe Example Design for Arrow EAGLE Board

CXL 2.0 support on the NEW Agilex™ 7 FPGA I-Series Development Kit (2x R-Tile and 1x F-Tile)