Stratix II EP2S180 DSP Development Board/Kit Santa Cruz Pin-out (PROTOX_CLKOUT)

Hi,

I have noticed that there's an error in the Stratix II EP2S180 DSP Development Board Reference Manual.

In figures 2-11 and 2-13, the signal named PROTO1_CLKOUT and PROTO2_CLKOUT are assigned to Stratix II pins AC14 and B14, respectively.

But I think that they are not!

These assignments are from the Stratix II EP2S60 Nios II Development Board. (I guess this is a CTRL+C - CTRL+V issue)

The correct Stratix II pins are T32 (for PROTO1_CLKOUT) and T30 (for PROTO2_CLKOUT) as it's specified in another section of the same document (Table 2-4, part 2, last row)

Just wanted to share the information, cause I haven't found an Errata Sheet regarding this issue.

Best Regards,

Gabriel