Forum Discussion
gustifix
New Contributor
New ContributorStratix 10 GX Dev Kit OpenCL: aocl diagnose error
Hello, In my previous post I got the Intel OpenCL BSP for Stratix 10 version 20.2 running on the Stratix 10 GX Dev Kit (part 1SG280HU2F50E2VG). After also adjusting the driver for Linux kernel 6.6, ...
aikeu
Regular Contributor
Regular ContributorHi Felix,
Can check if you have any problem running the FPGA board initialization?
Thanks.
Regards,
Aik Eu
gustifixNew Contributor
New ContributorHi Aik Eu,
The command "aocl initialize acl0 s10gx" reports "Program succeed." but "aocl diagnose acl0" still gives the errors. However, the first verification failure is not always at the same address and the total number of errors is also different.
Best regards
Felix
