Forum Discussion

Miles1's avatar
Miles1
Icon for New Contributor rankNew Contributor
3 years ago

Regarding the issue with the I2C Remote System Upgrade Example

I am using the 10M50D development board, ALTERA MAX 10 FPGA DEVELOPMENT KIT, to validate the I2C Remote System Update project as shown in the figure below. I am following the I2C Remote System Upgrad...
Fpga Devkit
Jeet14's avatar
Jeet14
Icon for Frequent Contributor rankFrequent Contributor
2 years ago

Hi,


Can I believe you have properly followed below these points without any error and without any change in hardware setup.


Hardware setup-page-10

Programming master Inamge into Max 10M50 Evaluation Kit-page-#11

Programming slave Inamge into Max 10M08 Evaluation Kit-page-#12

Programming slave Inamge-1 & 2 into CFM 1 & 2on Max 10M50-page-#13


Regards

Tiwari