Forum Discussion

Miles1's avatar
Miles1
Icon for New Contributor rankNew Contributor
3 years ago

Regarding the issue with the I2C Remote System Upgrade Example

I am using the 10M50D development board, ALTERA MAX 10 FPGA DEVELOPMENT KIT, to validate the I2C Remote System Update project as shown in the figure below. I am following the I2C Remote System Upgrad...
Fpga Devkit
Miles1's avatar
Miles1
Icon for New Contributor rankNew Contributor
3 years ago

I did not perform any compilation, I simply followed the steps on page 11 of the documentation to program the board.

However, when executing the steps on page 16 to send Slave Image 1 and Slave Image 2 via UART, I found that UART is not able to send out messages properly.

Is this related to using Quartus II v15.1?