Forum Discussion

GordWait's avatar
GordWait
Icon for New Contributor rankNew Contributor
1 year ago

New edition CVGT Board just arrived from Terasic. My already working programming script fails

We have some of "last year's" Cyclone V GT FPGA Development Kit boards in house. A shiny new one came in today after a long wait. It is supposed to be "exactly the same". Quartus programmer repor...
Board Debug
GordWait's avatar
GordWait
Icon for New Contributor rankNew Contributor
1 year ago

Yes, the error message is in my initial post, but I'll repeat it below.

The files from Intel only work with the old design, as it has a different flash device and as it turns out, different firmware for the Max V CPLD used as the flash controller. If I try to use those old files, it stops the on board flash completely and almost bricks the board.

I was able to read out the new Max V binary from a different new board and use that to restore the Max V on the board I'm testing.

Quartus programmer reports this error:

Error (18591): Can't recognize the Flash device that attached to device 2. The Flash device is not supported by Quartus Prime software.

I also get the same error from our programming script that has been working for a few years.

I have tried my older installed Quartus, and today just installed the latest 23.1 std edition. All report the same error.

FvM's avatar
FvM
Icon for Super Contributor rankSuper Contributor
1 year ago
Differences between both 1G CFI flash are small, but adaptions are probably necessary, e.g. for sector organization, if not already implemented in the original design.