Forum Discussion

Icon for New Contributor rank

New Contributor

5 years ago

Solved

N3000 PAC setup problem

Hi, I am setting up an Arria 10 N3000 PAC, and when I ran `sudo fpgainfo fme`, it shows the output as below. My MAX10 version is way too low, and is the Bitstream version: 0.00 and value for Pr Inter...

JonWay_altera
5 years ago
You need install the latest stack, and perform One Time Secure Update.

Icon for Frequent Contributor rank

Frequent Contributor

5 years ago

You need install the latest stack, and perform One Time Secure Update.

E-Hong
New Contributor
5 years ago
Hi,

Is this the latest stack mentioned above?

https://www.intel.com/content/www/us/en/programmable/products/boards_and_kits/dev-kits/altera/intel-fpga-pac-n3000/getting-started.html

I am using BD-NVV-N3000-2 (25 GbE), do I download v1.3.1, or just update and patch the version 1.1?

Thank you.
E-Hong
New Contributor
5 years ago
Hi,

I ran into this error when performing the One Time Secure Update.

Some information on the Linux.

Thank you.
- JonWay_altera
  Frequent Contributor
  5 years ago
  I’m glad that your question has been addressed in https://community.intel.com/t5/Intel-High-Level-Design/N3000-setup-Pr-Interface-ID-eeeeeeee-eeee-eeee-2222-222222222222/m-p/1281946#M1720
  
  I now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.