Forum Discussion

dkaws's avatar
dkaws
Icon for New Contributor rankNew Contributor
6 years ago

jtagconfig not working properly.

I'm using quartus 13.1 installed on ubuntu 12.04 (32-bit) in a Oracle VM. When I tried to connect my cyloneV SoC development kit some times it works but most of the time it's not working.it's very ra...
JohnT_Altera's avatar
JohnT_Altera
Icon for Regular Contributor rankRegular Contributor
6 years ago

Hi,

I think it is due to your system contain multiple Quartus version and it is usually used to load the firmware into the USB-BlasterII. May I know if you have USB-Blaster I?

dkaws's avatar
dkaws
Icon for New Contributor rankNew Contributor
6 years ago

I hv uninstalled all other quartus versions and now I have only quartus 13.1 installed in my PC.

------------------------May I know if you have USB-Blaster I?----------------------------

In my rules.d/usbblaster.rules file I have the following.

 "SUBSYSTEM==\"usb\", ATTR{idVendor}==\"09fb\", ATTR{idProduct}==\"6001\", MODE=\"0666\"" | sudo tee /etc/udev/rules.d/usbblaster.rules -a
"SUBSYSTEM==\"usb\", ATTR{idVendor}==\"09fb\", ATTR{idProduct}==\"6002\", MODE=\"0666\"" | sudo tee /etc/udev/rules.d/usbblaster.rules -a
 "SUBSYSTEM==\"usb\", ATTR{idVendor}==\"09fb\", ATTR{idProduct}==\"6003\", MODE=\"0666\"" | sudo tee /etc/udev/rules.d/usbblaster.rules -a
"SUBSYSTEM==\"usb\", ATTR{idVendor}==\"09fb\", ATTR{idProduct}==\"6010\", MODE=\"0666\"" | sudo tee /etc/udev/rules.d/usbblaster.rules -a
 "SUBSYSTEM==\"usb\", ATTR{idVendor}==\"09fb\", ATTR{idProduct}==\"6810\", MODE=\"0666\"" | sudo tee /etc/udev/rules.d/usbblaster.rules -a