Forum Discussion

Sathvika's avatar
Sathvika
Icon for New Contributor rankNew Contributor
2 years ago

JTAG pin connections for MAX 10 FPGA

I am making a design using 10M08SAE144C8G. Below is the schematic reference I am using . https://www.intel.com/content/dam/support/us/en/programmable/support-resources/fpga-wiki/asset01/bemicro-ma...
Fpga Devkit
FvM's avatar
FvM
Icon for Super Contributor rankSuper Contributor
2 years ago

Hi,
pin planner shows only JTAG signal pins, GND and VCC need to be also connected. For complete wiring of programming connector,
refer to MAX10 Device Handbook.

Additional pins are dedicated for AS memory programming, which has no function for MAX10.

Sathvika's avatar
Sathvika
Icon for New Contributor rankNew Contributor
2 years ago

What is AS?

And it is ok if we just use 4 pins from JTAG and connect them to FPGA. And leave remaining pins unconnected?

  • FvM's avatar
    FvM
    Icon for Super Contributor rankSuper Contributor
    2 years ago
    AS is active serial flash, used e.g. with Cyclone 10.

    4 JTAG pins + GND + VCC