Forum Discussion

Pouya1's avatar
Pouya1
Icon for New Contributor rankNew Contributor
3 years ago

Jtag chain broken for an Intel Stratix 10 MX board

Hi, I have an Intel Stratix 10 MX FPGA installed in a workstation. The board is powered up using an 8-pin AUX connector (in addition to pcie slot). I followed the user guide for HW/SW installat...
Pouya1's avatar
Pouya1
Icon for New Contributor rankNew Contributor
3 years ago

Thank you for your response @WZ2 !

Yes, I tried it with root access, too (I logged in as a super user using sudo su and ran jtagconfig) but again no success. I also, tested it with another miniUSB cable but it was not helpful. Since it takes time for me to test it with another sever, is there anything else I can test it before I move the FPGA card and install it in another server?

Thank you!

  • WZ2's avatar
    WZ2
    Icon for Frequent Contributor rankFrequent Contributor
    3 years ago

    I am not sure what device in the jtag chain rather than S10, please bypass them. And make sure the power of AUX is fixed.