Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

How to tap out signals if we don't have GPIO pins.

Hi all, we are using Stratix II GX PCI E development board. we are facing a typical problem for one of our projects that we have to tap out (connect) signals to another external board. There a...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

--- Quote Start ---

there are two HSMC ports available on the board but we are unaware of how to use them.

--- Quote End ---

How to understand this statement? These are connectors, the reference manual shows the pin mapping. The only problem is in identifying which signals are suitable for GPIO purposes and what't their bank voltage.

There is also a HSMC breakout debug board avaibale from Altera, that may be useful to interface the connectors. Otherwise, get the HSMC specification and design your own board or use a Samtec flat cable IDC connector.