Forum Discussion
Altera_Forum
Honored Contributor
Honored Contributorhow to flas EPCS on NIOS II Cyclone II kit
Hello everybody, First I beg your pardon for my poor english. I am using the Altera NIOS II Developpment Cyclone II kit but without NIOS !!! I have done my VHDL program and I can easyly fla...
Altera_ForumHonored Contributor
Honored ContributorThe two pins MSEL0 and MSEL1 are cannected to CPLD whitch drive the "boot selection", and there are 10k resistor to GND.
You cans see that on page 15 of the schematic of the board at : http://www.altera.com/literature/manual/cycloneii_niosii_2c35_rev02_db_sch.zip
