Forum Discussion

New Contributor

6 years ago

How to configure the UART-Usb port in a DE1 SOC fpga??

I have a trouble when I try to assign the pins of Rx and Tx UART ( my fpga is 5csema5f316N (Cyclone V SoC) in the Quartus II ( version 18.0) because the Table pins (I/O) show a reference PIN_B25 and ...

AR_A_Intel

Super Contributor

6 years ago

Hello

Welcome to INTEL forum. The DE1 SOC fpga Board belong to Terasic. It would be better if you could contact Terasic for enquiry related to Terasic board. https://www.terasic.com.tw/cgi-bin/page/archive.pl?Language=English&CategoryNo=12&No=20

Please accept my apologies for not being able to assist you fully as this is out of my expertise.

Forum Discussion

How to configure the UART-Usb port in a DE1 SOC fpga??

Recent Discussions

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).

Mandelbrot viewer on Cyclone V - Platform Designer layout

Slow Runtime Performance in FIL Implementation on DE2-115 Using Ethernet

Stratix 10 GX SI Board - issue with the Board Test System (BTS)

Stratix 10 Development Kit HiLo connector