Forum Discussion
Vinayk
New Contributor
New ContributorEPF6016QC240 VCCIO level query
As the FPGA(EPF6016QC240-3) powered up with 5V, am curious about the output voltage levels from the FPGA, are they going to be 5V outputs too ? Atleast from datasheet it shows they will be at 5V lev...
Hi,
Since this is legacy devices, I do not have much information to share here.
However, I found the device pin out information. Please refer to the link below for the pinout of the device:
Below link of the relevant documentation of the device:
FvM
Super Contributor
Super ContributorHi,
there's more information about Voh in the datasheet, see Figure 18:
According to the diagram, Voh doesn't comply with 5V CMOS Vih requirements. Notices that there's only 5V TTL but no 5V CMOS Voh spec in operation conditions. It's most likely possible to raise Voh with an external pull-up resistor.
