Forum Discussion
madhan_m
New Contributor
New ContributorDevice stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).
Using Agilex AGFB014R24A (E-Tile board). .jic flashes successfully, but no UART logs are observed after boot. Observed attached logs attached When programming the corresponding .sof via JTAG, ...
FakhrulA_altera
Regular Contributor
Regular ContributorHi madhan_m,
Could you try check this KDB:
https://community.altera.com/kb/knowledge-base/error18948-error-message-received-from-device-internal-error-subcode-0x001a-info/347566
Regards,
Fakhrul
