Forum Discussion
Altera_Forum
Honored Contributor
15 years agoThanks for the response! I did take care of the VGA_BLANK_N and VGA_SYNC_N signals already and went back to my DE1 and started from scratch. So far the projects works on the DE1. So, I'm going to start a more formal port instead of just throwing code in expecting it to work.
Previously, I did take a look at the data sheet for the VGA chip but brushed it off not thinking it would make my module not functional. This was a mistake on my part and I should have know hardware isn't as forgiving as I'd like it to be sometimes. I'll take a deeper look at the difference between the boards and figure out any new signal propagation I may need to implement. Thanks for the advice!