Forum Discussion
New ContributorDE0-nano usb blaster issue
Hello everyone.
Got issues with DE0-nano dev board.
We tried to configure the flash memory and flash converted .jic file to it.
Memory wasn't presented in the available list in Flash Loader, so we created our own Configuration Device and config flash using this manual:
https://www.programmersought.com/article/68485809297/
memory type presented on our de0-nano - S25LP064
After flashing the created .jic file board usb blaster stops detecting in a system, so seems board get "bricked".
A main question is, how is it possible to recover the board in this case? To get usb blaster detected again.
3 Replies
BXiaOccasional Contributor
Hi @avgustine13 ,
As DE0-nano is Terasic board, you can contact Terasic directly via [email protected] regard this issue.
FakhrulA_alteraRegular Contributor
Hello avgustine13,
I apologize for overlooking your post. Could you please share the error message from Quartus?
Regards,
Fakhrul
- FakhrulA_altera
Please be advised that due to the absence of a response from you regarding the previous notification we provided, we will be transitioning this thread to community support. If you have any new questions or concerns, we kindly suggest opening a new thread to receive assistance from Intel experts. However, if you do not have any further inquiries, the community users will be available to assist you on this thread. Thank you for your understanding.
