Forum Discussion

New Contributor

2 years ago

Cyclone V: reaching RGMII Data to Clock output skew of +/- 500ps

What is best practice to reach the 500ps Data to Clock output Skew of RGMII specification v2.0 on a Cyclone V? Trying synthesizing a TSE MAC with RX-Clock to TX-Clock loopback fails because of timin...

Fpga Devkit

ShengN_altera

Super Contributor

2 years ago

Hi Jodok,

Check this KDB link https://www.intel.com/content/www/us/en/support/programmable/articles/000079123.html, it's recommended to select the PHY with ability to adjust its input timing.

Thanks,

Regards,

Sheng

Forum Discussion

Cyclone V: reaching RGMII Data to Clock output skew of +/- 500ps

Recent Discussions

yolov3_tiny_tf run_inference_stream problem

Looking for guidance on CXL IP access (university research, Agilex 7 I-series)

DE10-Lite and sdram controller ip

JTAG Chain Broken – Unable to Program Agilex 5 Modular Development Board

DK-DEV-AGI027RES Install Package