Cyclone V: configure FPGA fabric from HPS to update SPI Flash

Question

Dear support,We have a Cyclone SoC V SE (hard processor HPS + FPGA fabric) configured by a serial SPI flash.We need to update the SPI flash from the HPS + LinuxFrom the read documentation, it seems possible to:- Upload the new configuration file to a non volatile memory (OK, already done)- Configure the FPGA fabric in order to give access of the SPI flash to the HPS- Update the SPI flash from the HPSIs there any relevant application note / user guide to program the FPGA fabric and update the SPI flash ?I found some application note for Agilex but not for Cyclone V.Regards,WabG

wabg · Answer

To help the community, the FPGA fabric access is realized through the FPGA manager and it's available only for some MSEL configurations. In our case, unfortunately, our board don't have the right configuration so we can't reconfigure the FPGA fabric.

aikeu · Answer

Hi WabG,I think this is a duplicate case from another forum case 06186025 link:https://community.intel.com/t5/FPGA-SoC-And-CPLD-Boards-And/SoC-Cyclone-V-Configure-FPGA-fabric-SPI-Flash-from-HPS/m-p/1587039#M27257I will close this thread and follow up from the other link.Thanks.Regards,Aik Eu

aikeu · Answer

Hi WabG,I am closing this thread for now as this is a duplicate case from another forum case 06186025 link:https://community.intel.com/t5/FPGA-SoC-And-CPLD-Boards-And/SoC-Cyclone-V-Configure-FPGA-fabric-SPI-Flash-from-HPS/m-p/1587039#M27257Thanks.Regards,Aik Eu

Forum Discussion

Cyclone V: configure FPGA fabric from HPS to update SPI Flash

3 Replies

Recent Discussions

Regarding Quartus Prime License Activation for the Agilex 5 Evaluation Kit

Stratix 10 FPGA Dev Kit VCCIO_FMC voltage issue

DE10-Lite unable to flash?

Mandelbrot viewer on Cyclone V - Platform Designer layout

A question about reading the configuration space of the R-Tile PCIe IP EP