Cyclone IV GX PCIe End Point

Question

hi,

I started in the morning with the Altera Board Cyclone IV Gx. Can anyone has any tipps to deal with PCIe Design in order to integrated any others interfaces ? or Design examples?

Please I need this urgently...........

I would be thankful for any advices

altera_forum · Answer

Hi,  do you mean the DBCGX15 Board? I have made a small Design with NIOS2 DDR2 RAM and the PIOs. What do you want to do?

altera_forum · Answer

Hi

I have to deal with the board Cyclone IV GX Tranceiver Starter Kit.

For that I need:

1) Undestand any Design Example relating to GPIO , SRAM , UART, at least.

So if you have any Designs just help me to move forward

Regards,

altera_forum · Answer

My Board name is EP4CGX15BF

altera_forum · Answer

Hi again,

sorry but I have no designs for this board. But if you install the Kit-Installation which you can get from here, you should get some reference designs installed, too.

http://www.altera.com/products/devkits/altera/kit-cyclone-iv-starter.html

Forum Discussion

Cyclone IV GX PCIe End Point

4 Replies

Recent Discussions

MAX10 10M50 Development KIT Triple Speed Ethernet problem

About PCIe Daughter Cards for Agilex™ 3 FPGA and SoC C‑Series Development Kit

Stratix 10 FPGA Dev Kit VCCIO_FMC voltage issue

Stratix 10 Development Kit HiLo connector

Technical Assistance Request for Stratix® 10 SX SoC Development Kit (so#488775)