Forum Discussion

manishkumar's avatar
manishkumar
Icon for New Contributor rankNew Contributor
1 year ago

Cyclone® V FPGA – Remote System Upgrade over UART Based on Nios® II Processors with EPCQ Design Exam

with given reference design example try to program the output_file.jic file through Quartus prime programmer as per the reference user manual in to the (Cyclone V E FPGA Development Kit) , but it is...
Fpga Devkit
totolo's avatar
totolo
Icon for New Contributor rankNew Contributor
1 year ago

Hi,
I encountered the same issue, the JIC programming failed, and I can't even erase the flash. The component at the U2 position on my C5E development board is not an EPCQ256 but a 2WA15 RW164. How should I deal with this?