Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

Configuring the Stratix2 device

Hi, Am using stratix2 device in my design. I have configured bank3 lines as LVDS inputs, however with this configuration am not able to program the device. I get the error nCE pin didn't g...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

The following " To Customer " note was posted:

" Hi Srikanth,

Thanks for your prompt response.

This is a known issue of the Stratix II devices. The solution was posted online at www.altera.com/support/kdb/solutions/rd01262005_186.html (http://www.altera.com/support/kdb/solutions/rd01262005_186.html) . Kindly please refer to the errata sheet Page 11, Table 7 at http://www.altera.com/literature/ds/esstx2fpga.pdf and follow the instruction recommended according to the device used.

Hope that the information will resolve your inquiries. Kindly please get back to us if you still having any inquiries.

Thanks for using mySupport.

Best Regards,

LF Hoe. "