Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

Configuring the Stratix2 device

Hi, Am using stratix2 device in my design. I have configured bank3 lines as LVDS inputs, however with this configuration am not able to program the device. I get the error nCE pin didn't g...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

Hi,

Thanks for your time.

Sorry for the wrong information. Its bank5. I tried by setting the unused pins to input tri-stated.

But the problem seems to be something else. The design is using a single port ram and I enabled the option of using "In system memory content editor to read the contents of RAM" was not able to program the device.

Then again compiled the design by disabling the above option then I was able to load the design into the device.

But I need to read the contents of RAM during the run time! Is there any setting?

Thanks n Regards

Srikanth