Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

communication between Cyclone III and MAX II in Cyclone III development kit

Hello, We are working on Cyclone III 120 dev. kit. I could not figure it out from the reference manual about communication facility between MAXII and Cyclone III devices. my task is to im...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Thanks for the suggestions FvM. I will ask Altera about USB_PHY_xxx usage.

I have a question here. So, If I erase the MAXII logic and implement a USB interface inside it, do you think it is possible to use those JTAG Config and PM config lines (as shown in fig 2-3, page 2-7 in Cyclone III reference manual) to send USB_FIFO status lines like full, empty, data present ...

Thanks again