Forum Discussion

PK16's avatar
PK16
Icon for New Contributor rankNew Contributor
2 years ago

Altera cyclone v fpga board not working

The board we have altera cyclone v fpga. After giving power supply, only 12v power supply LED is glowing. The rest are not working like normal displaying of 7 segment display, other red, green lEDS. ...
Board Debug
PK16's avatar
PK16
Icon for New Contributor rankNew Contributor
2 years ago

I got the schematic sheet of C5G. Please go through this, in page 9, there is power circuit of c5g is there.

Thanks

  • lixy's avatar
    lixy
    Icon for Contributor rankContributor
    2 years ago

    Hi,

    Thanks for providing this schematic!

    From Page 21, we can see that VCC3P3 signal is controlling the 3.3V Power LED D6.

    To understand which component is defected, you can measure some point's Voltage to GND.

    VCC3P3 Test Point Pad,

    R57/R60 both sides to GND (Measure the voltage to ground at both ends of the resistor separately),

    R184 both sides to GND,

    L12 both sides to GND,

    R47 both sides to GND.

    I think by checking these points, we will at least understand which component is defected.

    Best Regards,

    Xiaoyan