Forum Discussion

New Contributor

5 years ago

Running in the cloud and calling both FPGA and GPU, how to modify Makefile, url, run.sh .

Running in the cloud and calling both FPGA and GPU, how to modify Makefile, url, run.sh . And Is it okay to use the following command qsub -d . build.sh?

General

RaeesaM_Intel

New Contributor

5 years ago

Hi,

Thank you for posting in Intel Forums.

We are forwarding this case to FPGA forum for much faster and adequate response.

Forum Link : https://community.intel.com/t5/Intel-High-Level-Design/bd-p/high-level-design

Regards,

Raeesa

Forum Discussion

Running in the cloud and calling both FPGA and GPU, how to modify Makefile, url, run.sh .

Recent Discussions

This is a test post

Agilex 7 M series Open FPGA Stack support

Deprecation Notice for FPGA Support Package for oneAPI DPC++/C++. What is the alternative?

Agilex 7 I-Series "aocl diagnose acl0" error following OFS

OneAPI Support for Agilex 5 and 7 Development Kits