Forum Discussion
Iukas
New Contributor
New ContributorCreating PCB based on 10M08 Evaluation Board but with other MAX10 FPGA
Hello everyone, for a school project, I want to design a PCB for / around the MAX 10 FPGA. As I'm trying to make my life easier, I am using this (https://www.intel.com/content/www/us/en/products/det...
Farabi_Altera
Regular Contributor
Regular ContributorHello Lukas,
I am taking over this case from previous owner.
You may refer to : https://www.intel.com/content/www/us/en/docs/programmable/683658/current/i-o-vertical-migration-support.html
Part number you are using is in the vertical migration list. So the replacement should be drop-in replacement. Just change the part number in your Quartus project file and re-compile.
regards,
Farabi
