Most RecentWhy do I see PTP failure due to accuracy error exceeding 3ns in Basic PTP Timestamp Accuracy Mode on F-Tile Ethernet Hard IP when dynamically reconfiguring from 100G-4 PTP to 4x25G PTP without FEC on hardware using example design from the F-Tile Suite?Why is the external loopback test failing for the GTS Dynamic Reconfiguration Controller IP in the GTS PMA/FEC Direct PHY example design?Why does design compilation in the Quartus® Prime Pro Edition software version 25.3 and earlier fail during the fitter stage when the “Remove Redundant Logic Cells” option is enabled, and the F-Tile Dynamic Reconfiguration Suite IP is used in the design?Why do the HPS Synopsys DesignWare APB timers fail to initialize in Linux* during the early boot stage in the FPGA HPS Embedded Software 25.1.1 and earlier?Why do I see the ERROR: IOSSM: inline_ecc_bist_mem_init: Timeout init memory on IO96B_0 error message during the ATF to Linux* Direct flow in Agilex® 5 FPGA device using LPDDR memory with in-line ECC enabled?Why do I see the "CLK 300027 Multiple clock assignment found" DRC error on the 25 MHz and 2.5 MHz clocks from the HPS GMII to RGMII Adapter IP?Why does the ATF to Linux* Direct boot flow fail to boot from SD/eMMC in Quartus® Prime Pro version 25.1.1 and earlier when ATF is built with ARM* GCC compiler version 12.2 or higher on Agilex® 5 FPGA or Agilex® 3 FPGA devices?Why does the RSU update cause the HPS to hang in Stratix® 10 FPGA devices with bitstreams containing large fabric designs from Quartus® Prime Pro version 25.1.1 and earlier?Why do I see warnings recommending to use auto adaptation mode for CPRI rates that are below 7Gbps of Agilex® 5 FPGA GTS CPRI PHY IP?Why do I see simulation error for GTS CPRI PHY IP Dynamic Reconfiguration Example Design about o_rx_patterndetect_x2 causing cross-module reference error?