Most RecentIs there any known issue when enabling the Open Drain Programmable I/O Element Feature of an Agilex™ 5 FPGA HPS IO?Why are multiple quartus_sh.exe processes running even after I close the Quartus II software?Error (11574): ATX PLL node <ATX PLL node name> uses an output frequency of <configured data rate> MHz that exceeds the maximum frequency of 13200.0 MHz in the targeted speed grade <device speed grade> for a Bottom ATX PLL in a transceiver bankWhy does the p<n>_ss_app_st_tx_ready signal go to X in simulation of 40GbE and 50GbE Agilex™ 7 F-Tile variants of the Ethernet Subsystem FPGA IP ports when the Enable Preamble Passthrough parameter is selected.What are the valid pre-emphasis pre-tap settings for Stratix® V GT FPGA channels?Why HPS booting from QSPI will hang after we configure the HPS cold reset register on CV SoC dev kit?Error(18948): Error message received from device: Detected corrupted configuration data at location 0x00008400Error: : Component <component_name> not found or could not be instantiated qsys-generate failed with exit code 3Why do the DDR4 memory interface signals show values of ‘hxx in the waveforms of the example testbench simulation?Can the MMR interface be used in conjunction with the Efficiency Monitor in the External Memory Interface Intel® FPGA IP?
