Forum Discussion

alhussain779's avatar
alhussain779
Icon for New Contributor rankNew Contributor
3 years ago

Power Monitor is not working on Stratix 10

Hello, I am trying to measure the power consumption of a design in my FPGA device using the Power Monitor utility that came with Board Test System. However, when I open it I get the following messa...
AqidAyman_Altera's avatar
AqidAyman_Altera
Icon for Regular Contributor rankRegular Contributor
3 years ago

Hi Alhussain,


I think this might be very likely with the Terasic board that you are using. I am not 100% confident on this but there might some differences between the board and our Intel Stratix 10 development kit.


When looking to Terasic DE10-Pro SX User Manual, I observed that the power monitor circuit is connected to S10 and not MAX 10 as our Intel® Stratix® 10 SX SoC Development Kit.


Refer to the attached snapshot from both documentations. We suspected Terasic have their own application written to read power monitor.


Regards,

Aqid