Forum Discussion
rMa1
New Contributor
New ContributornCONFIG pin abnormal
Arria10 10AS016C4 used in my project, we use 10Kohm/0402 and 1Kohm/0402 respectively as pullup resister for nCONFIG in my board, nCONFIG pin goes to low, and resistor between nCONFIG and GND is 26ohm...
NurAiman_M_Intel
Super Contributor
Super ContributorHi,
Thank you for contacting Intel community.
Kindly refer to pin connection guidelines below for further information:
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/dp/arria-10/pcg-01017.pdf
Let me know if you need further assistance.
Regards,
Aiman
