Forum Discussion

Shiva's avatar
Shiva
Icon for New Contributor rankNew Contributor
7 years ago

MAX 10 FPGA Remote System Upgrade (RSU)

Hi, I am trying remote system upgrade for MAX10 FPGA device, Here i am able to write and read the rpd data of CFM1 but when i trigger the reconfiguration it is not getting reconfigured. I am doing t...
JohnT_Altera's avatar
JohnT_Altera
Icon for Regular Contributor rankRegular Contributor
6 years ago

Hi,

Could you use MCU to send 1 word data (4 byte) to read from address ".SECTOR3_START_ADDR (8192), //hex value = 2000" and use the SignalTap to monitor the signal? I would like to see what you observed on MCU and the SignalTap to determine the issue?