Forum Discussion

MDISC's avatar
MDISC
Icon for New Contributor rankNew Contributor
6 years ago

MAX 10 FPGA JAM Staple error

Hi, I am trying to program a MAX10 FPGA device by embedded JAM Staple utility modified to run on microcontroller on my board. I am able to do this operation when the device is already programmed s...
MDISC's avatar
MDISC
Icon for New Contributor rankNew Contributor
6 years ago

Sorry for the delay in my response. I have verified the configuration with JAM Staple software using parallel port and ByteBlaster probe works properly.

I made some mistakes in the data management during the configuration command.

I was misled by the fact that all other writing and reading operations via JTAG were working properly.

Thanks in any case.