Forum Discussion

mm_s2's avatar
mm_s2
Icon for New Contributor rankNew Contributor
4 years ago

EQFP144

Hi, I have a question about the Cyclone 10 FPGA Part Number 10CL010YU144I7G, because for my prototype i have to solder the FPGA pins manually. What can happen when the FPGA is powered by power p...
NurAiman_M_Intel's avatar
NurAiman_M_Intel
Icon for Super Contributor rankSuper Contributor
4 years ago

Hi,


Thank you for contacting Intel community.


The exposed pad is a ground pad that must be connected to the ground plane on your PCB and it is used for electrical connectivity, and not for thermal purposes. Failing to solder the exposed pad to ground will cause the device to hold in a reset state and all types of configuration modes will fail.


Kindly refer to Cyclone 10 LP pin connection guidelines.

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/dp/cyclone-10/pcg-01021.pdf


Regards,

Aiman