Forum Discussion
New ContributorCompilation Start won't work
I'm working on a very simple logic gate diagram and want to compile it, but the program wont let me access that option. I don't have an FPGA board installed and was wondering if that would be the cause. I just need to find the Truth values of the diagram I've produced.
1 Reply
CalvinJoaz_P_IntelContributor
Hi Wasi,
Good day.
You still can compile program without FPGA board installed.
What tool you're using?
Refer link below if you're using Quartus tool.
ftp://ftp.intel.com/Pub/fpgaup/pub/Intel_Material/13.0/Tutorials/VHDL/Quartus_II_Introduction.pdf
ftp://ftp.intel.com/Pub/fpgaup/pub/Intel_Material/13.0/Tutorials/VHDL/Quartus_II_Simulation.pdf
Refer link below if you're using Modelsim Simulation.
ftp://ftp.intel.com/Pub/fpgaup/pub/Intel_Material/15.0/Tutorials/VHDL/Using_ModelSim.pdf
Hope this could be helpful.
Let me know if this has helped resolve the issue you are facing or if you need any further assistance.
Thank you.
