Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

Where is "EMIF IP byte enable option"?

Hi! I have a SoC FPGA board (DE1 SoC) and did a setup using AVALON MM reading and writing 8bit from the HPS (Linux), now I wanted to extend the bit width to 128bit. When I generated the component set...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

Oh, I'm following various tutorials. I understand that building, pin assignment, and AFAIR all that is done in Quartus II ends up to be a TCL command which eaqually could be written directly, as well. It is true that most of the tutorials mention this point. I can't see, though, how to debug the TCL on the other side, if it was buggy.

If you have a tutorial/link that talks more about how to work with the _hw.tcl, I would appreciate to know! :)