--- Quote Start ---
Hi!
I am using the waveform editor in Quartus II. Everything works fine, I can add IN and OUT nodes and I can see the simulation results. But now I need to set some BURRIED nodes to specific values. I can do this in the waveform editor but this doesn't affect the simulation results. It seems that the simulation always uses the init values for BURRIED nodes.
Is there a way to set the BURRIED nodes to specific values for the simulation?
Regards,
Andre
--- Quote End ---
Hi Andre,
as far as I know it is not possible to force internal node with the waveform editor.
Kind regards
GPK
Honored Contributor
