Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

unused prn/clrn inputs

Noob question if I may. In the schematic editor, how should I pull up unused prn/clrn inputs to a flip flop? Currently I tie them to an unassigned input pin default vcc. Circuit works fine, but ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Hi,

Can you please brief your question with Schematic editor (screenshot), what are you trying to do & what issue are you facing?

Best Regards

Vikas Jathar

(This message was posted on behalf of Intel Corporation)