Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Uart

Hi. i have one design that is UART written in verilog code. The simulation is successfully done. However, when i program my design to the DE2 board and connect it to the PC using the RS232, there i...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

update: The code works fine for the DE2-70 board. Just make sure that Quartus does not complain about set-up and hold times. :)

i got a de-70 board and realized now that the sample code is not working on it right away. i will try to figure out if it is caused by the different rs232 chip on the board or if my interface causes the problem.

from my perspective the code should be fine. i will post an update once i solved the problem.

Spellic

@Colors: I have no experience with the NIOS stuff, maybe you post your request somewhere else? Besides, I am referring here to the DE2 boards with Cyclone II FPGA. I don't think those two chip family's are compatible.