Forum Discussion

gyuunyuu's avatar
gyuunyuu
Icon for Contributor rankContributor
5 years ago

SignalTap does not show trigger pulse at the same sample number everytime

In SignalTap II it is possible to specify the trigger position as e.g as centre trigger position. When trigger condition is met, the sample number where the condition was met will always be at the sa...
RichardT_altera's avatar
RichardT_altera
Icon for Super Contributor rankSuper Contributor
5 years ago

May I know does the sstrell's suggestion help in anyway for your case? Do you need further help on this?

gyuunyuu's avatar
gyuunyuu
Icon for Contributor rankContributor
5 years ago

I cannot share the full design now. I shall see if/when it occurs in a dummy design, I shall share it here.

  • sstrell's avatar
    sstrell
    Icon for Super Contributor rankSuper Contributor
    5 years ago

    You could just post Signal Tap screenshots, including the Data and Setup tabs. You don't really need to post the design itself.

  • RichardT_altera's avatar
    RichardT_altera
    Icon for Super Contributor rankSuper Contributor
    5 years ago

    Any update from your side?

    • gyuunyuu's avatar
      gyuunyuu
      Icon for Contributor rankContributor
      5 years ago

      Please close this item for now as I cannot provide an image to you at this time.

      • RichardT_altera's avatar
        RichardT_altera
        Icon for Super Contributor rankSuper Contributor
        5 years ago

        Thanks for your confirmation to close this case. I will now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.

        Best Regards,
        Richard Tan

        p/s: If any replies from the Intel or community support are helpful, please feel free to give Kudos.