Problems working thru "Using Triple-Speed Ethernet on DE2-115 Boards"

problem is with the tutorial's supplied tse_tutorial.v being incompatible with the new TSE.... I modified it like this:

nios_system system_inst(

.clk_clk (sys_clk), // clk.clk

.reset_reset_n (core_reset_n), // reset.reset_n

//modified to this 10/10/2013:

// .tse_mac_conduit_connection_rx_control (NET1_RX_DV), // tse_mac_conduit.rx_control

.tse_mac_mac_rgmii_connection_rx_control (NET1_RX_DV),

// .tse_mac_conduit_connection_rx_clk (NET1_RX_CLK), // .rx_clk

.tse_mac_pcs_mac_rx_clock_connection_clk (NET1_RX_CLK),

// .tse_mac_conduit_connection_tx_control (NET1_TX_EN), // .tx_control

.tse_mac_mac_rgmii_connection_tx_control (NET1_TX_EN),

// .tse_mac_conduit_connection_tx_clk (tx_clk), // .tx_clk

.tse_mac_pcs_mac_tx_clock_connection_clk (tx_clk),

// .tse_mac_conduit_connection_rgmii_out (NET1_TX_DATA), // .rgmii_out

.tse_mac_mac_rgmii_connection_rgmii_out (NET1_TX_DATA),

// .tse_mac_conduit_connection_rgmii_in (NET1_RX_DATA), // .rgmii_in

.tse_mac_mac_rgmii_connection_rgmii_in (NET1_RX_DATA),

// .tse_mac_conduit_connection_ena_10 (ena_10), // .ena_10

.tse_mac_mac_status_connection_ena_10 (ena_10),

// .tse_mac_conduit_connection_eth_mode (eth_mode), // .eth_mode

.tse_mac_mac_status_connection_eth_mode (eth_mode),

// .tse_mac_conduit_connection_mdio_in (mdio_in), // .mdio_in

.tse_mac_mac_mdio_connection_mdio_in (mdio_in),

// .tse_mac_conduit_connection_mdio_out (mdio_out), // .mdio_out

.tse_mac_mac_mdio_connection_mdio_out (mdio_out),

// .tse_mac_conduit_connection_mdc (mdc), // .mdc

.tse_mac_mac_mdio_connection_mdc (mdc),

// .tse_mac_conduit_connection_mdio_oen (mdio_oen) // .mdio_oen

.tse_mac_mac_mdio_connection_mdio_oen (mdio_oen)

//END modifications 10/10/2013

 );

and the design compiled in Quartus. (this isn't the whole file, just the part of it I modified)

Now... have to see if the code will run on it.