Forum Discussion

Honored Contributor

8 years ago

Problems to program Cyclone V GT FPGA

Im new using Altera boards I have two questions. I check the Quartus_II_Introduction for verilog users. On the programming chapter it says that "DE0-CV, DE0-Nano and DE2-115 Boards" should have a...

Altera_Forum

Honored Contributor

8 years ago

Hi,

1.We dont have such switch but take care SW4.4 and SW5 setting for programming.

For more information you can refer user guide https://www.altera.com/en_us/pdfs/literature/ug/ug_cvgt_fpga_dev_kit.pdf

2.For pin related information,use reference guide https://www.altera.com/en_us/pdfs/literature/manual/rm_cvgt_fpga_dev_board.pdf

Best Regards,

Anand Raj Shankar

(This message was posted on behalf of Intel Corporation)

Forum Discussion

Problems to program Cyclone V GT FPGA

Recent Discussions

ram retiming

Reset Release IP for Agilex needs Stratix 10 device files installed!

Licensing ‘Know-How’ Guide

Timing analysis - long combinational path

Invalid license key (inconsistent authentication code)