Forum Discussion

Blues-sptn's avatar
Blues-sptn
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

Platform Designer(Cyclone10GX、Quartus Prime18.1 build222)でのアドレスマッピ設定について

Platform Designer（Cyclone10GX、Quartus Prime18.1 build222） にて、以下３種のIPにてシステムを構成しているのですが、 64bitのベースアドレス設定がうまくいきません。 具体的には、64bit設定しても強制的に32bit設定となってしまいます。 ※バージョンは異なりますが、CycloneVで同様の構成実績あり​ ​ Platfo...
BoonT_Intel's avatar
BoonT_Intel
Icon for Frequent Contributor rankFrequent Contributor
6 years ago

Based on the document, seem like turn on this feature will make the address become 64bits. But its still give me 32 after turn on this feature.

Do you have successful case that can allow you to change the address from 32 to 64? I am asking this because I remember you mentioned that you can set the address 1_0000_0000 in other device family?

Also, may I why you want to set the based address to 1_0000_0000? Usually user will prefer the smaller address which is 0000_0000.