OpenCL diagnose not working

Hi,

Franz, thanks for the advice:

--- Quote Start ---

I was in the same situation. The reason was, that the v14 hello_world.rbf from Bittware (or any other v14 rbf for the board) has to be loaded to the fpga and flash with _unchecked_ "compressed" box in bwconfig-gui (it is now fixed in the doc and there is a thread featuring this in this forum). After that, the board driver should be loaded automatically.

--- Quote End ---

I tried to follow your suggestion about loading the example with the "compressed" box unchecked but didn't work. I ended up downloading an example compiled with v13 and now the card is recognized when doing "aoc diagnostic".

Now, with lspci a few things have changed. I was just wondering that even though it says "Unassigned device", everything seems ok:

01:00.0 Unassigned class : Altera Corporation Device d800 (rev 01)
        Subsystem: Altera Corporation Device 0005
        Flags: bus master. fast devsel, latency 0, IRQ 16
        Memory at f0000000 (64-bit, prefetchable) 
        Capabilities: <access denied>
        Kernel driver in use: aclpci
        Kernel modules: acl_pci_drv

Thank you guys for the help,

Carlos