Forum Discussion

sagarsonavaneBH's avatar
sagarsonavaneBH
Icon for New Contributor rankNew Contributor
5 years ago

On chip ADC hangs up in 10M50DAF256I76

We are using the part 10M50DAF256I76 in one of our designs. In this design we are using the available on chip modular dual ADC. The interface for the ADC is generated inside QSYS with the following ...
sagarsonavaneBH's avatar
sagarsonavaneBH
Icon for New Contributor rankNew Contributor
5 years ago

Does this means that we should never set the "run bit" to "1" in single cycle conversion mode?

OR

Should we first write 0x02 to CMD register, wait for a delay of approx. 1ms, and then set "run bit" to "1" in single cycle conversion mode i.e. write 0x03 to CMD Register